Roland HP-207 Electronic Keyboard User Manual


 
10
Important Notes
Other Cautions
551
Stored content may be lost due to a malfunction of the
device or because of inadvertent operation. You should
back up important content on USB memory as a safeguard
against such loss.
552
We cannot accept responsibility for the recovery of any
content lost from internal memory or USB memory, or for
the consequences of such loss.
553
Do not apply excessive force to the buttons, knobs, or
input/output jacks, since this may cause malfunctions.
554
Do not apply strong pressure to the display or strike it.
556
When connecting or disconnecting cables, grasp the plug
(not the cable) to prevent short circuits or broken
connections.
557
This device may produce a certain amount of heat, but this
is not a malfunction.
558a
Please enjoy your music in ways that do not inconvenience
other people nearby, and pay particular attention to the
volume at nighttime. Using headphones will allow you to
enjoy music without having to be concerned about others.
559b
When transporting or shipping this device, package it in an
appropriate amount of cushioning material. Scratches,
damage, or malfunctions may occur if you transport it
without appropriate packaging.
560
If using the music rest, do not apply excessive force to it.
562
Some connection cables contain a resistor. Do not connect
such cables to this device. Doing so may make the volume
extremely low or inaudible. Please use connection cables
not containing a resistor.
565
Before opening or closing the keyboard lid, always make
sure that no pets or other small animals are located on top
of the instrument (in particular, they should be kept away
from the keyboard and its lid). Otherwise, due to the
structural design of this instrument, small pets or other
animals could end up getting trapped inside it. If such a
situation is encountered, you must immediately switch off
the power and disconnect the power cord from the outlet.
You should then consult with the retailer from whom the
instrument was purchased, or contact the nearest Roland
Service Center.
Floppy Disk Handling
(Using Optional Floppy Disk Drive)
651
Floppy disks contain a plastic disk with a thin coating of
magnetic storage medium. Microscopic precision is
required to enable storage of large amounts of data on
such a small surface area. To preserve their integrity,
please observe the following when handling floppy disks:
Never touch the magnetic medium inside the disk.
Do not use or store floppy disks in dirty or dusty areas.
Do not subject floppy disks to temperature extremes
(e.g., direct sunlight in an enclosed vehicle).
Recommended temperature range: 10–50 degrees C
(50–122 degrees F).
Do not expose floppy disks to strong magnetic fields,
such as those generated by loudspeakers.
652
Floppy disks have a “write protect” tab which can protect
the disk from accidental erasure. It is recommended that the
tab be kept in the PROTECT position, and moved to the
WRITE position only when you wish to write new data onto
the disk.
fig.DiskProtect.e.eps
653
The identification label should be firmly affixed to the disk.
Should the label come loose while the disk is in the drive, it
may be difficult to remove the disk.
654
Store all disks in a safe place to avoid damaging them, and
to protect them from dust, dirt, and other hazards. By using
a dirty or dust-ridden disk, you risk damaging the disk, as
well as causing the disk drive to malfunction.
Rear side of the disk
Write
(can write new data onto disk)
Protect
(prevents writing to disk)
Write Protect Tab
HP207_e.book 10 ページ 2006年12月25日 月曜日 午前9時52分