Filter
Top Products
88
Settings common to all modes (System Function)
Settings that affect the entire operating environment of the JUNO-D,
such as tuning and MIDI message reception, are referred to as
system functions
. This section explains how to make settings for
the System functions and describes the functions of the different
System parameters. The parameters are organized into the following
six groups.
•
GENERAL:
Make settings common to the entire system (p. 89).
•
CONTROLLER:
Make controller-related settings (p. 89).
•
MIDI:
Make MIDI-related settings (p. 90).
•
PATCH SCALE (Patch Scale Tune):
Make scale tune settings for a patch (p. 91).
How to make the system
function settings
1.
Press [SYSTEM] so it is lit.
2.
Select the parameter that you want to edit.
“Selecting system setting parameters”
(p. 88)
3.
Use VALUE [-]/[+] to modify the value.
4.
Repeat steps 2–3 to make the settings for the System
function.
Changes you make to the system function settings are
temporary, and will be lost when you turn off the power. If you
want to save the settings you modified, perform the following
operation.
5.
To save the settings you modified, press [WRITE].
fig.r12-01_40
6.
Press [ENTER] to execute.
When you save system settings, the previously saved settings
will be overwritten and lost.
If you decide not to save the system function, press [EXIT].
Selecting system setting parameters
fig.r12-02
PAGE/
CURSOR [ ]
PAGE/
CURSOR [ ]
GENERAL
PAGE/
CURSOR [ ]
PAGE/
CURSOR [ ]
PAGE/
CURSOR [ ]
PAGE/
CURSOR [ ]
PAGE/
CURSOR [ ]
PAGE/
CURSOR [ ]
[SHIFT]
+
PAGE/
CURSOR [ ]
[SHIFT]
+
PAGE/
CURSOR [ ]
MIDI
[SHIFT]
+
PAGE/
CURSOR [ ]
[SHIFT]
+
PAGE/
CURSOR [ ]
PAGE/
CURSOR [ ]
PAGE/
CURSOR [ ]
PAGE/
CURSOR [ ]
PAGE/
CURSOR [ ]
PAGE/
CURSOR [ ]
PAGE/
CURSOR [ ]
PATCH SCALE
CONTROLLER
[SHIFT]
+
PAGE/
CURSOR [ ]
[SHIFT]
+
PAGE/
CURSOR [ ]
JUNO-D_e.book 88 ページ ２００４年６月１１日 金曜日 午後１時２１分