Filter
Top Products
Restoring the settings to the factory condition (Factory Reset)
MIDI Pedalboard PK-9
r
17
ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH
●
Factory Reset
Refer to “Restoring the settings to
the factory condition (Factory Reset)”
on p. 17.
●
MIDI Dump
Refer to “Archiving and restoring
your settings (MIDI Dump)” on p. 17.
●
Save
Refer to “Saving the settings (Save
function)” on p. 14.
Restoring the settings to the
factory condition (Factory Reset)
The settings you’ve changed in Parameter mode
(page 14) can be restored to their factory-set condition.
This operation is called “Factory Reset.”
1.
Simultaneously press the [CONTROL 1] and
[CONTROL 2] pedals.
The [CONTROL 1] and [CONTROL 2] indicators flash.
2.
Press the [CONTROL 1] or [CONTROL 2]
pedal to select the “FAC” parameter.
3.
Press the Hold pedal to confirm.
When the Factory Reset has been completed, the dis-
play will indicate “ok” and the PK-9 will leave Param-
eter mode.
Archiving and restoring your
settings (MIDI Dump)
You can archive and restore your settings using a com-
puter (with a MIDI interface, commercially available) or
an external sequencer.
Getting ready to archive/restore
1.
Use a MIDI cable (commercially available) to
connect the MIDI IN socket of external
sequencer to the PK-9’s MIDI OUT socket.
2.
Use another MIDI cable to connect the MIDI
OUT socket of the external sequencer to the
PK-9’s MIDI IN socket.
3.
Switch on the external sequencer and the
PK-9.
NOTE
To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn off
the power on all devices before making any connections.
Archiving your settings to the external sequencer
1.
Simultaneously press the [CONTROL 1] and
[CONTROL 2] pedals.
The [CONTROL 1] and [CONTROL 2] indicators flash.
2.
Press the [CONTROL 1] or [CONTROL 2]
pedal to select the “dMP” parameter.
3.
Activate data reception or recording on the
external device.
4.
Wait until the sequencer’s count-in (if
applicable) is finished and press Hold pedal
to start the MIDI Dump.
When the MIDI Dump has been completed, the dis-
play will indicate “ok” and the PK-9 will leave Param-
eter mode.
FAC
dmp
SAv
Note: Your computer may have to
be connected to a MIDI interface.
The PK-9 needs to be connected
to the MIDI interface.
MIDI OUT
MIDI IN
MIDI IN
MIDI OUT
PK-9_multi.book Page 17 Monday, April 23, 2012 3:03 PM