Filter
Top Products
17
Before You Start Playing
The RG-1 has two jacks for plugging in headphones. This
allows two people to listen through headphones
simultaneously, making it very useful for lessons and
performing piano pieces for four hands. Additionally, this
allows you to play without bothering others around you,
even at night.
fig.00-0420
1.
Plug the headphones into a Phones jack located
in the jack panel on the RG-1’s bottom left panel.
Connecting headphones will automatically mute the
sound from the internal speakers.
The headphone volume is adjusted by the [Volume]
knob of the RG-1.
NOTE
• Use Stereo headphones.
• To prevent damage to the cord, handle the headphones
only by the headset or the plug.
• Connecting the headphones when the volume of
connected equipment is turned up may result in damage
to the headphones. Lower the volume on the RG-1
before plugging in the headphones.
• Listening at excessively high volume levels will not only
damage the headphones, but may also cause hearing
loss. Use the headphones at a moderate volume level.
Whenever you are not using the headphones, you can hang
them on the headphone hook of the RG-1.
1.
Press and twist the headphone hook included
with the RG-1 into the hole in the bottom left of
the RG-1 (refer to the figure below).
2.
Turn the headphone hook wing nut to secure the
headphone hook.
NOTE
Do not hang anything other than headphones on the
headphone hook. Doing so may damage the instrument
or the hook.
Connecting Headphones
Using the Headphone Hook
Headphone hook
Wing
nut
RG-1_e.book 17 ページ ２００８年４月８日 火曜日 午後２時３６分