Filter
Top Products
46
Playing Back Songs
3
Press the [ ] button.
The songs on the CD are played.
When the RG-1 is set to play back all songs (p. 70), once the song currently
being played back is finished, the next song starts playing automatically.
After all of the songs on the CD have been played, playback automatically
resumes from the beginning of the CD.
When the RG-1 is set to play back a single song (p. 70), playback stops
automatically when the song is finished.
• Press the [ ] button to move to the beginning of the next song.
• Press the [ ] button to move to the beginning of the currently
selected song. If you’re already at the beginning of the song, you will
move to the beginning of the preceding song.
• If you hold down the [ ] button while a song is playing, the song
will fast-forward.
• If you hold down the [ ] button while a song is playing, the song
will rewind.
4
Press the [ ] button once more to stop playback of the songs.
Turning Off the Power (When a CD Drive Is Connected)
1
Stop playback if the CD is being played back.
2
Eject the CD.
3
Lower the piano’s volume all the way, then switch off its power
(p. 16).
4
Turn off the power to the CD drive.
NOTE
If you are unable to eject the
CD, try the following
procedure.
If after these steps you are
still unable to get the CD to
eject, read the CD drive
owner’s manual.
1. Turn off the power to all
connected devices.
2. Turn on the RG-1.
3. Turn on the CD drive.
4.
Wait a few moments after
the power is switched on,
then firmly press the eject
button.
NOTE
Before detaching the cable for
the CD drive, make sure that
the power for all equipment
has been switched off.
RG-1_e.book 46 ページ ２００８年４月８日 火曜日 午後２時３６分