Filter
Top Products
8
HINT: To set a precise delay time that matches a song’s tempo, tap your finger on
the TAP button in time with the song. If it’s slightly off, use the Fine Control to match
it perfectly.
STEP ON IT! If the optional foot controller is connected, you can set the delay time
by tapping your foot.
HINT: To defeat Bypass, press the TAP button once again.
2.5 Value Knobs 1–3
In Program Select mode and Manual mode, these knobs adjust the effect. The
knobs will edit the effect you selected by its TYPE button (i.e., the effect whose
button is lit). For details on the parameters that these three knobs adjust, refer
to p.34 and following. (From the left, these knobs are called value knobs 1–3.)
When you are making UTILITY or GLOBAL settings, you can use value knob 3
to edit the value.
NOTE: For some effect settings, undesired distortion may occur. If this happens,
lower the CH VOLUME.
BANK/MANUAL/WRITE/TUNER/CHANNEL SECTION
Phew, the “Bank/Manual/Write/Tuner/Channel Section?” What a mouthful! Don’t
stress though – just because this area houses a few different things doesn’t mean
it’s complicated. In fact, as you’re about to discover, it’s both logical and simple ...
honest! This section is simply where you select and view programs, and see the
names and values of the amp and effect section parameters that are creating your
sound. This is also where you make UTILITY and GLOBAL settings.
3.1 BANK Display
This displays the program bank.
3.2 BANK/VALUE ▲, ▼ Buttons
In Program Select mode, use these buttons to select one of the eight (8) pro-
gram banks. When making UTILITY or GLOBAL settings, use these buttons to
edit parameters or values.
If you press ▲ and ▼ simultaneously, you will enter Manual mode.
3.3 CHANNEL SELECT/MENU & CURSOR 1/PREV, 2/NEXT, 3/√√
√√
, 4/®®
®®
But-
tons
In Program Select mode, use these buttons to select a channel within each
bank. When making UTILITY or GLOBAL settings, use these buttons to select
a menu or parameter.
3.4 UTILITY Button
This lets you assign a name to a program, adjust the Noise Reduction and set
up the optional foot controller.
Press the UTILITY button to make the button light, and then use the 1/PREV or
2/NEXT buttons to move through the menu items listed below.
After selecting the desired menu item, use value knob 3 or the ▲, ▼ buttons to
change the value.
3