Filter
Top Products
16
GETTING TO PROGRAM SELECT MODE
Here’s how to get to Program Select Mode. When you enter Program Select Mode,
the bank number (1–24) will appear in the bank display (3.1).
If the bank display shows “ ” (Manual Mode)
This means that ToneLab is in Manual Mode. Do one of the following actions to
return to Program Select Mode.
• Press any one of the channel select 1–4 buttons (3.3).
• Simultaneously press the BANK ▲ and ▼ buttons (3.2).
If any of the UTILITY (3.4), GLOBAL (3.5), WRITE (3.6), or TUNER (3.7) buttons
are lit or if the bank display is blinking (3.1)
• Press the TUNER/CANCEL button (3.7). You will return to the mode you
were previously in.
If Manual Mode is selected, get to Program Select Mode by doing any of the
above actions.
MANUAL MODE: What You See is What You Get!
When ToneLab is in MANUAL MODE it behaves like a “regular” amp – meaning
that the sound you hear is a direct reflection of all the knob settings of the amp
section.
NOTE: Any changes you make in Manual Mode to the effect section and UTILITY
parameters (other than “EXP INIT”) will be remembered. The next time you enter
Manual Mode, those settings will be recalled.
SWITCHING TO MANUAL MODE
In Manual Mode, the bank display (3.1) shows “ ”.
If ToneLab is in Program Select Mode (the bank display shows a number).
• Simultaneously press the BANK ▲ and ▼ buttons (3.2).
If any of the UTILITY (3.4), GLOBAL (3.5), WRITE (3.6), or TUNER (3.7) buttons
are lit
• Press the TUNER/CANCEL button (3.7). You will return to the mode you
were previously in.
If ToneLab is in Program Select Mode, switch to Manual Mode as described
above.