Filter
Top Products
TunerFoot
Controller
MIDI/DIGITAL
Factory
settings
Trouble-
shooting
Spec.Program
List
51
Restoring the Factory Preset
Programs
ere’s how you can restore ToneLab’s programs and all its other settings to
the state in which it was shipped from the factory.
NOTE: This operation will permanently erase all the programs you’ve written or
tweaked yourself. MIDI settings and settings you made in Manual Mode will also be
erased. If there are any settings you want to keep, use Data Dump to back them
up, or use a copy of the “Program Sheet” foldout at the end of this manual to make
a note of your settings.
1. While holding down the three buttons ▲, ▼ (3.2), and TUNER/CANCEL (3.7),
press the STANDBY button to turn on the power.
The bank display (3.1) “P” and the CHANNEL SELECT 1–4 buttons (3.3) will
blink, and the name display (3.8) will ask “RELOAD?” Release the three but-
tons you were holding down.
2. If at this point you decide that you really don’t want to execute this operation,
you can press the TUNER/CANCEL button.
3. Press the WRITE/ENTER button (3.6). The name display (3.8) will show
“LOADING,” and the factory-set data will begin being reloaded.
When reloading has been completed, the name display will indicate “COM-
PLETE,” and ToneLab will automatically switch to Program Select Mode.
NOTE: Never turn off the power while this reload operation is occurring.
H