Filter
Top Products
TunerFoot
Controller
MIDI/DIGITAL
Factory
settings
Trouble-
shooting
Spec.Program
List
49
BACKING UP
1. Connect ToneLab’s MIDI OUT to the MIDI IN of the device that will receive the
data dump.
2. If you want to transmit only one program, use Program Select Mode to select
the program you want to transmit. If you want to transmit the Manual Mode set-
tings, select Manual Mode.
3. Press the GLOBAL button (3.5) to make the button light.
4. Press the 1/PREV or 2/NEXT switch (3.3) to make the name display (3.8) read
“DUMP CUR” or “DUMP ALL.”
“DUMP CUR” (Dump current program data): The data of the currently selected
program will be dumped. If you are editing the program (and have not yet
saved it), the current settings will be transmitted.
“DUMP ALL” (Dump all data): All of the ToneLab’s data will be dumped.
5. Put the receiving device in a state in which it can record the data dump.
NOTE: For details, refer to the owner’s manual of the device that will receive the
data dump.
6. Press ToneLab’s WRITE/ENTER button (3.6) to begin transmission. When
transmission is completed, the display will indicate “COMPLETE,” and you will
return to the screen of step 4. (While “DUMP ALL” is being transmitted, the dis-
play will indicate “SEND.”)
NOTE: While data is being transmitted, do not touch the buttons or knobs of
ToneLab or its foot controller, and never turn off the power.
RESTORING
1. Connect the transmitting device’s MIDI OUT to ToneLab’s MIDI IN.
2. Set the transmitting MIDI device and ToneLab to the same MIDI channel. If
ToneLab will be receiving data that was previously transmitted to the external
MIDI device, select the same MIDI channel as was used when transmitting.
3. Transmit the data dump from the external device.
While ToneLab is receiving all data, its display will indicate “RECEIVE.” When
reception has been successfully completed, it will indicate “COMPLETE.” If an
error occurs, the display will indicate “ERROR”; in this case, try transmitting the
data again.
NOTE: For details, refer to the owner’s manual of the device that will be transmit-
ting the data dump.
NOTE: While data is being received, do not touch the buttons or knobs of ToneLab
or its foot controller, and never turn off the power.
4. If ToneLab received data for just one program in Program Select Mode, select
the store-destination bank and channel, and store the program. (p.20)
NOTE: The program data will not be written into ToneLab’s program memory
unless you store it.
If you received data in Manual Mode, settings other than for the amp section will be
overwritten automatically, so you don’t need to store the settings yourself. (Since