Filter
Top Products
TunerFoot
Controller
MIDI/DIGITAL
Factory
settings
Trouble-
shooting
Spec.Program
List
47
2. Press the 1/PREV or 2/NEXT button (3.3) to make the name display (3.8)
show “PCHG OUT.”
3. Specify whether program change messages will be transmitted. Use value
knob 3 (2.5) or the ▲, ▼ buttons (3.2) to make the desired setting.
“OFF”: Program change messages will not be transmitted.
“On”: Program change messages will be transmitted.
CONTROL CHANGE (GLOBAL “CCHG I/O”)
When you operate the EXPRESSION pedal, VOLUME pedal, or TAP switch of an
optional foot controller connected to ToneLab, control change messages will be
transmitted. This means that functions for the corresponding control change num-
bers on an external MIDI device can be controlled in realtime.
Similarly, when ToneLab receives control change messages from an external MIDI
device, it will be controlled in the same way as if its own foot controller were oper-
ated.
For a list of the functions that can be controlled from an external MIDI device, refer
to step 4.
Here you can specify whether ToneLab will transmit and receive control change
messages.
1. Press the GLOBAL button (3.5) to make the button light.
2. Press the 1/PREV or 2/NEXT button (3.3) to make the name display (3.8) read
“CCHG I/O.”
3. Specify whether all control change messages will be transmitted or received.
Use value knob 3 (2.5) or the ▲, ▼ buttons (3.2) to make your choice.
“On” allows transmitting and receiving. “OFF” disables transmitting and receiv-
ing.
NOTE: If this setting is “OFF,” no control change messages will be transmitted or
received even if you specify individual control change numbers in step 4.
4. Use the 3/√√
√√
or 4/®®
®®
buttons to select the controller for which you want to trans-
mit or receive settings. The controllers will be selected in the following order.
5. For each controller, specify whether ToneLab will transmit and receive control
change messages. If you want ToneLab to transmit and receive messages for
a controller, specify the control change number. Select a controller, and use
value knob 3 (2.5) or the ▲, ▼ buttons (3.2) to make the desired setting.
“OFF”: Control change messages will not be transmitted or received.
“EXP PDL”: EXPRESSION pedal control
“VOL PDL”: VOLUME pedal control
“TAP SW”: TAP switch on/off
“PEDAL FX”: PEDAL effect on/off
“MOD FX”: MODULATION effect on/off
“DELAY FX”: DELAY effect on/off
“REVRB FX”: REVERB effect on/off