Filter
Top Products
38
4. PHASER
A model of a much respected and popular analogue phaser, housed in a banana
yellow box!
5. TREMOLO
This effect is based on the highly acclaimed tremolo circuit found in a BLACK
2x12.
The SPREAD setting lets you create panning effects that are spread to left
and right.
6. ROTARY
This models a stereo rotary speaker.
When you adjust the SPEED control of the ROTARY effect (either via the
front panel or the optional foot controller) the effect takes awhile to reach the spec-
ified speed - just like a real rotating speaker. Why? Because, in the real world, it
takes a second or two for the motor controlling the speaker rotation to speed up or
slow down! (You can use TIME to adjust the length of this transition.)
E. DELAY EFFECTS
Here you can make settings for a delay effect inserted after the cabinet. You can
choose one of three (3) distinctly different delay effects. In all three cases, the
maximum delay time possible is two seconds.
[1] “SPEED” 0.100...10.00 [
Hz](EX)
Adjusts the modulation speed.
[2]
“RESO(RESONANCE)”
0.0...10.0 Adjusts the amount of resonance.
[3] “DEPTH” 0.0...10.0 Adjusts the modulation depth.
(*) MANUAL 1.0...10.0 Adjusts the center frequency of the
sweep.
[1] “SPEED” 1.00...10.00
[Hz](EX)
Adjusts the tremolo speed.
[2] “SPREAD”0.0...10.0 Adjusts the left/right spaciousness.
[3] “DEPTH” 0.0...10.0 Adjusts the tremolo depth.
[1] “SPEED” 0.80...10.00
[Hz](EX)
Adjusts the rotational speed of the speaker.
[2] “TIME” 1.0...10.0 Adjusts the time required for the rotational
speed to change.
[3] “DEPTH” 0.0...10.0 Adjusts the modulation depth.
(EX):
This indicates a parameter that you can control from the expression pedal
of the optional foot controller.
(*): This indicates a parameter that you can set when using the Sound Editor.
These parameters cannot be edited when using ToneLab alone.
DELAY FINE: knob 1 MIX: knob 2 FEEDBACK: knob 3
DELAY/TAPE ECHO/MULTI HEAD
“TIME” 0...2000 [ms] “MIX” 0.0...10 “FEEDBACK” 0.0...10