Filter
Top Products
46
NOTE: You will need a MIDI interface in order to connect your computer with
ToneLab.
Some USB-MIDI interface devices may not be able to transmit/receive the
ToneLab’s MIDI exclusive messages.
SETTING THE MIDI CHANNEL (GLOBAL “MIDI CH”)
In order to exchange data with an external MIDI device, ToneLab’s MIDI channel
must match the MIDI channel of your external MIDI device. Here’s how to set the
MIDI channel.
1. Press the GLOBAL button (3.5) to make the button light.
2. The name display (3.8) will show “MIDI CH.” If a different parameter is
selected, press the 1/PREV or 2/NEXT button (3.3) to change the display.
3. Use the value knob 3 (2.5) or the ▲, ▼ buttons (3.2) to set ToneLab’s MIDI
channel.
4. Set the MIDI channel of your connected external MIDI device.
For details on how to set the MIDI channel of your external MIDI device, refer
to its owner’s manual.
PROGRAM CHANGE (GLOBAL “PCHG OUT”)
When you switch programs on ToneLab or on a connected foot controller, a pro-
gram change message is transmitted from the MIDI OUT jack, causing an external
MIDI device to switch programs. Similarly, when ToneLab receives a program
change message, its program will switch automatically. Here’s how you can spec-
ify whether a program change message will be transmitted from the MIDI OUT
jack when you switch programs on ToneLab or on a connected foot controller.
NOTE: Program change numbers not used by ToneLab will be ignored. For details
on the range of program change numbers used by ToneLab, refer to “MIDI Imple-
mentation Chart” (p.54).
NOTE: When ToneLab is in Manual Mode, it will ignore program change mes-
sages; programs will not be switched. In Program Select Mode, program changes
are always received.
1. Press the GLOBAL button (3.5) to make the button light.
ToneLab
MIDI IN MIDI OUT
MIDI IN
MIDI OUT
To a MIDI sequencer/computer
MIDI interface
Dedicated foot controller