Filter
Top Products
Using Headphones
CGP-1000 Owner’s Manual
17
Introduction
For the longer stay, use the inner recess, and for the shorter stay, use the outer
recess to support the lid.
■ To close the lid:
1 Hold the lid stay and carefully raise the lid.
2 Hold the lid in its raised position and lower the
lid stay.
3 Carefully lower the lid.
Using Headphones
Connect a pair of headphones to one of the
[PHONES] jacks located on the bottom left of the
instrument.
Two sets of standard stereo headphones can be
connected. (If you are using only one pair of
headphones, you can plug them into either of
these jacks.)
Using the Headphone Hanger
A headphone hanger is included in the Clavinova
package so that you can hang the headphones on the
Clavinova. Install the headphone hanger using
included two screws (4 x 10mm) as shown in the fig-
ure.
Longer stay
Shorter stay
CAUTION
Do not use the outer recess
for the longer stay; doing so
could make the lid unstable
and may cause it to fall,
resulting in damage or injury.
CAUTION
•Make sure that the end of
the stay fits securely in the
lid recess. If the stay is not
properly seated in the
recess, the lid may fall, caus-
ing damage or injury.
• Be careful that you or oth-
ers do not bump the stay
while the lid is raised. The
stay may be bumped out of
the lid recess causing the lid
to fall.
• Be careful to avoid catching
fingers (yours or others,
especially children’s) when
raising or lowering the lid.
• Do not place any objects on
the soundboard or the jer-
sey cloth part; doing so may
disturb the sound and even
damage the instrument.
CAUTION
Do not listen with the head-
phones at high volume for
long periods of time. Doing
so may cause hearing loss.
CAUTION
Do not hang anything other
than the headphones on the
hanger. Otherwise, the
Clavinova or the hanger may
be damaged.
1
3
2
Outputting sound from the speaker while headphones are con-
nected
1 Call up the operation display.
[FUNCTION]→ [I] UTILITY → TAB[
√
][
®
] CONFIG 2
2 Press the [3
ππ
ππ
††
††
]/[4
ππ
ππ
††
††
] (SPEAKER) button to select “ON.”
Outputting sound only from the headphones
From the display called up in step 2 above, press the [3
ππ
ππ
††
††
]/[4
ππ
ππ
††
††
]
(SPEAKER) button to select “OFF.”
When “OFF” is selected, the speakers will not sound and you can only hear
the Clavinova sound via the headphones.