Filter
Top Products
Using, Creating and Editing Voices
Editing the Volume and Tonal Balance (MIXING CONSOLE)
CGP-1000 Owner’s Manual
98
■ Editing and Saving the selected Master Compressor
6 Use the [1
ππ
ππ
††
††
]/[2
ππ
ππ
††
††
] buttons to select the frequency curve for the
Compressor, or which frequencies compression is applied to.
For example, select “LOW” when you want to emphasize low frequencies,
and “HIGH” when you want to emphasize high frequencies.
7 Use the [3
ππ
ππ
††
††
]–[7
ππ
ππ
††
††
] buttons to determine the Threshold (mini-
mum level at which compression starts) and Gain (level of com-
pressed signal at three separate frequency bands).
These values offset those of the frequency curve settings in step 6.
8 Press the [I] (SAVE) button to call up the display for saving your origi-
nal Master Compressor settings.
9 Use the [3
ππ
ππ
††
††
]–[6
ππ
ππ
††
††
] buttons to select the destination for saving
the Master Compressor settings.
10 Press the [I] (SAVE) button to save the Master Compressor settings
(page 69).
When recalling the saved Master Compressor settings, use the same proce-
dure as in step 4.
67
8
Threshold:
Determines the minimum level
at which compression starts. The
compressor affects only the
sound of levels higher than that
of Threshold.
9
10