112 CLP-295GP Owner’s Manual
Appendix
2. Attach two front legs and a rear leg.
Refer to the diagram below to verify the orientation of
the legs.
Install and tighten four 6 x 40 mm screws on each leg,
starting with one of the front legs.
3. Install the pedal box.
1 Remove the twist tie that affixes the pedal
cord to the upper portion of the pedal box.
2 Align the cord with the groove on the unit,
and attach the pedal box using four
6 x 20 mm
screws.
3 Insert the pedal cord plug into the pedal
connector. Insert the plug so the arrow side
faces front (toward the keyboard).
If the plug will not go in easily, do not
force it. Double-check the orientation of
the plug, then try again.
4 Attach the cord holder on the unit as shown
in the illustration below, then use the cord
holder to affix the pedal cord.
4. Raising the unit to the standing posi-
tion.
Use the front legs as support to raise the unit.
Rear leg
Front leg Front leg
Twist tie
4
3
CAUTION
•Be careful not to pinch your fingers.
•When you raise the unit, do not hold the key
cover.