Filter
Top Products
43
Effect Functions
■
01: Transpose
The Transpose function makes it possible to shift the pitch of the entire keyboard
up or down in semitone intervals up to a maximum of six semitones. “Transposing” the
pitch of the Clavinova keyboard makes it easier to play in difficult key signatures, and
you can simply match the pitch of the keyboard to the range of a singer or other instru-
mentalist.
Once the Transpose function has been selected, use the TEMPO [s] and [t] but-
tons to select the desired degree of transposition, then release the [UTILITY] button.
The amount of transposition selected is shown on the display as shown to the left.
NOTES
• Press the TEMPO [
s
] and [
t
] buttons simultaneously while holding the [UTILITY]
button (while the Transpose function is selected) to restore normal keyboard pitch.
• Transpose is always set to Normal when the power is turned on.
• The transpose function does not affect the drums sound.
• Notes below and above the original 88-key range of the Clavinova sound one octave
higher and lower, respectively.
⁄¤‹›‚01 TRANSPOSE
0
Display Transposition
-6 -6 semitones
-5 -5 semitones
-4 -4 semitones
-3 -3 semitones
-2 -2 semitones
-1 -1 semitone
0 Normal
+1 +1 semitone
+2 +2 semitones
+3 +3 semitones
+4 +4 semitones
+5 +5 semitones
+6 +6 semitones
■ 02: Chorus ON/OFF
A preset chorus effect is provided with each of the CVP-89 voices (this may be ON
or OFF, depending on the voice). This function allows the chorus effect to be turned
ON or OFF for the currently selected voice.
Once the Chorus ON/OFF function has been selected, use the TEMPO [s] and
[t] buttons to turn the chorus effect ON or OFF, then release the [UTILITY] button.
NOTES
• The chorus ON/OFF setting is retained in memory for approximately one week even
when the power is turned off.
• See page vii for a list of the chorus settings for each voice.
• In the Dual mode the setting of the voice shown to the left of the display takes priority,
while in the Split mode the right-hand voice setting takes priority.
⁄¤‹›‚02 CHORUS
Piano OFF
Utility Functions
■ 04: Mic Reverb Depth
This function sets the amount of reverb effect applied to the signal from a micro-
phone plugged into the CVP-89 MIC. jack (page 65).
Once the Mic Reverb function has been selected, use the TEMPO [s] and [t]
buttons to set the depth of the reverb effect, then release the [UTILITY] button. The
microphone reverb depth can be set from “0” (no reverb) to “15” (maximum reverb).
The default setting is “8”.
⁄¤‹›‚04 MIC REVERB DEPTH
8
■ 03: Soundboard Depth
The CVP-89 PIANO voice ( voice number 1) features a “Soundboard” effect which
can be enhanced via the damper pedal. Extra soundboard and string resonance is added
when the damper pedal is pressed. This function sets the maximum depth of the
Soundboard effect.
Once the Soundboard Depth function has been selected, use the TEMPO [s] and
[t] buttons to set the depth of the effect as required, then release the [UTILITY] but-
ton. The Soundboard Depth can be set from “0” (no effect) to “15” (maximum effect
depth). The default setting is “8”.
NOTES
• The Soundboard Depth setting is retained in memory for approximately one week
even when the power is turned off.
⁄¤‹›‚03 SOUNDBOARD DEPTH
8