5.
Press
or to select the appropriate setting, and then press .
6. Press Menu to exit the menu.
Jam recovery
Use this option to configure the printer response to jams, including how the printer handles the pages
involved. AUTO is the default value.
● AUTO: The printer automatically turns jam recovery on when sufficient memory is available.
●
ON: The printer reprints any page that is involved in a jam. Additional memory is allocated to
store the last few pages that were printed, and this might cause overall printer performance to
suffer.
●
OFF: The printer does not reprint any page that was involved in a jam. Because no memory is
used to store the most recent pages, overall printer performance might be optimized.
To set the jam-recovery response
1. Press Menu to open the menus.
2.
Press
to highlight CONFIGURE DEVICE, and then press .
3.
Press
to highlight SYSTEM SETUP, and then press .
4.
Press
to highlight JAM RECOVERY, and then press .
5.
Press
or to select the appropriate setting, and then press .
6. Press Menu to exit the menu.
RAM disk
This option determines how the RAM disk feature is configured. This option is available only if the
printer has at least 8 MB of free memory. The default is AUTO.
●
AUTO: The printer determines the optimal RAM disk size based on the amount of available
memory.
●
OFF: The RAM disk is disabled, but a minimal RAM disk is still active (sufficient to scan one
page).
To set the RAM disk
1. Press Menu to open the menus.
2.
Press
to highlight CONFIGURE DEVICE, and then press .
3.
Press
to highlight SYSTEM SETUP, and then press .
4.
Press
to highlight RAM DISK, and then press .
5.
Press
or to select the appropriate setting, and then press .
6. Press Menu to exit the menu.
ENWW Changing printer-control-panel configuration settings 41
