Filter
Top Products
Description of Controls - Chapter 5
Q20 Reference Manual 81
Effect Parameters
The following charts are designed to act as a Òroad mapÓ to assist you in locating
parameters and their value ranges. All of the following parameters may be found
by first selecting the appropriate effect type, pressing the [PARAMETER] button,
and using the [< PAGE >] buttons to navigate through the various pages. The
number of pages available depends on the effect type youÕve selected. The total
number of pages will be shown in the left side of the display, and the currently
selected page number will have an underline beneath it.
Equalization
EQ T
yp
e Parameters Pa
g
e#
Lowpass Filter Lowpass Fc (frequency): 20Hz-10kHz 1
Bandpass Filter Bandpass Fc: 200Hz-10kHz,
BW (bandwidth): 0.20-2.50 Octaves
1
Highpass Filter Highpass Fc: 100Hz-20kHz 1
Lowpass Shelf Lowpass: 20Hz-10kHz, Gain: ± 14dB 1
Highpass Shelf Highpass: 100Hz-20kHz, Gain: ±14dB 1
1 Band Low
Parametric
Bandpass: 20Hz-2000Hz, Gain: ± 14dB,
BW: 0.20-2.00 Octaves
1
1 Band High
Parametric
Bandpass: 200Hz-10kHz, Gain: ±14dB
BW: 0.20-2.50 Octaves
1
2 Band Sweep Lowpass: 20Hz-10kHz, Gain: ±14dB 1
Shelf Highpass: 100Hz-20kHz, Gain: ±14dB 2
3 Band Parametric Lowpass: 20Hz-10kHz, Gain: ±14dB 1
Mid Band: 200Hz-10kHz, Gain: ±14dB,
BW: 0.20-2.50 Octaves
2
Highpass: 100Hz-20kHz, Gain: ±14dB 3
4 Band Parametric Lowpass: 20Hz-10kHz, Gain: ±14dB 1
Low Mid: 20Hz-2kHz, Gain: ±14dB,
BW: 0.20-2.00 Octaves
2
High Mid: 1500Hz-10kHz, Gain: ±14dB,
BW: 0.20-2.50 Octaves
3
Highpass: 100Hz-20kHz, Gain: ±14dB 4
5 Band Graphic 63Hz/250Hz/1kHz/4kHz/16kHz: ±14dB
Note: All bands have a two octave bandwidth.
1
Resonator Resonator Tuning: A0-A5 (4 Octaves), Decay 0-99 1
Mono Tremolo Speed: 0-99, Depth: 0-99, Shape: Soft/Hard 1
Stereo Tremolo Speed: 0-99, Depth: 0-99, Shape: Soft/Hard 1
Stereo Simulator Stereo Spread: 0-99 Degrees 1
Soft Overdrive Effect Mix: Overdrive/Clean 1
Brightness: 0-99, Drive Level: 1.0-11.0 2
Hard Overdrive Effect Mix: Overdrive/Clean 1
Brightness: 0-99, Drive Level: 1.0-11.0 2
Triggered Panning Speed: 0-99, Doppler: 0-99, Distance: 0-99 1
Retrigger Point: Left/ Right/ Alternating L/R 2
Sweeping Mode: Continuous/One Cycle Only 3
Trigger Source: Audio Left, Audio Right, Audio
L&R, Advance Footsw., Bypass Footsw.
4
Phase Inverter Output Phase: Inverted/Non-Inverted 1