Filter
Top Products
Chapter 6 - Advanced Applications
92 Q20 Reference Manual
Choosing a Target
Once you have selected a Modulator, you must then select the Target to be
modulated. The Target is broken down into two parts: first, you choose one of the
active Blocks in the current Program, then you choose a parameter within the
Block.
➀ With [MODULATION] selected (its LED should be lit), press [PAGE >].
The cursor will advance to the second field in the display:
MOD 1 TO: D LY 1-TAP 1 DELAY TIME
The cursor appears beneath the Modulator Target Block.
➁ Turn the [VALUE/ENTER] knob to select a Block.
The display will look different depending on each BlockÕs defined type. In the
display example above, the first Block is a Delay (DLY). The number (1) tells
us this is Block #1. If you turn the [VALUE/ENTER] knob, you will see other
options defining the BlockÕs type and number (example: PCH 2, EQ 3, OUT L,
MIX, etc.).
➂ Press [PAGE >] to advance the cursor to the next field in the display.
MOD 1 TO:DLY 1- T AP 1 DELAY TIME
The cursor appears beneath the Modulator Target Parameter.
➃ Turn the [VALUE/ENTER] knob to select a Parameter to be modulated in the
selected Block.
The parameters available will of course depend on the selected BlockÕs type.
Here is a list of possible Target Parameters, listed with each effect type:
T
yp
e Effect Tar
g
et
EQ Lowpass Filter Frequency
Bandpass Filter Bandpass Frequency, Bandpass Width
Highpass Filter Frequency
Lowpass Shelf Frequency, Gain
Highpass Shelf Frequency, Gain
1 Band Low/High
Parametric
Bandpass Gain
Bandpass Width
2 Band Sweep Shelf Lowpass Frequency, Lowpass Gain
Highpass Frequency, Highpass Gain
3 Band Parametric EQ Lowpass Frequency, Low pass Gain
Bandpass Frequency, Bandpass Gain
Bandpass Width
Highpass Frequency, Highpass Gain