Filter
Top Products
Applying Effects to Tones
E-28
You can save up to 100 modified DSPs in the user area for
later recall when you need them.
User DSP areas 100 through 199 initially contain the same
data as DSP types 000 through 099.
1. After making the DSP parameter settings you
want, press the [ ] CURSOR button.
This causes the DSP number of the user area
where the DSP will be saved to flash on the
display.
2. Use the [
+
] and [–] buttons to select the user
DSP area number where you want to save the
new DSP.
You can select a user DSP area number in the
range of 100 to 199 only.
3. After the user DSP area number you want is
selected, press the [ ] CURSOR button.
Use the [
+
] and [–] buttons to scroll through
letters at the current cursor location.
Use the [ ] and [ ] CURSOR buttons to move
the cursor left and right.
See the page E-49 for information about inputting
text.
4. After everything is the way you want, press the
[ ] CURSOR button to store the effect.
This will display a confirmation message asking
whether you really want to save the data. Press
the YES button to save the data.
The message “Complete” appears momentarily
on the display, followed by the tone or rhythm
selection screen.
Checking the DSP button will tell you whether or not DSP is
enabled for the tone that is currently selected for a part. The
DSP button will be lit for a tone that is DSP enabled (DSP line
ON), and unlit for a tone that is DSP disabled (DSP line OFF).
For example, when you move each part while using the split/
layer function, the DSP button lights or goes out in
accordance with that parts setting.
Pressing the DSP button toggles the tone of the part you are
currently playing on the keyboard between enabled (DSP line
ON) and disabled (DSP line OFF).
1. Press the DSP button to toggle DSP line for the
currently selected part on and off.
Perform the following steps to select REVERB.
1. Press the EFFECT button, so the pointer
appears next to EFFECT on the display screen.
1 Pointer
2. Press the [ ] CURSOR button once.
This displays the reverb editing screen.
3. Press the [ ] CURSOR button.
The reverb type setting screen will appear
automatically about fives seconds after you press
the button.
4. Use the [
+
] and [–] buttons or the number
buttons to scroll through the reverb types until
the one you want is displayed, or use the
number buttons to input the reverb number you
want to select.
See the list on page A-18 for information about
the types of REVERB effects that are available.
Here you could also change the parameters of the
effect you selected, if you want. See “Changing
the Settings of REVERB Parameters” for more
information.
You can control the relative strength of a reverb and how it is
applied. See the following section titled “REVERB
Parameters” for more information.
Saving the Settings of DSP Parameters
DSP Button
To turn DSP line on and off
Selecting REVERB
Changing the Settings of REVERB
Parameters
705A-E-030B