Filter
Top Products
Synthesizer Mode
E-46
The group of tone numbers from 600 through 699 (User 001 through User 100) is called the “user area” because they are reserved
for storage of user tones. After you recall a preset tone and change its parameters to create your own user tone, you can store it in
the user area for later recall. You can recall your tones using the same procedure that you use when selecting a preset tone.
*1: You can select any Advanced Tone, preset tone, or user tone. User tone areas 600 through 699 initially contain the same data
as DSP types 000 through 099.
*2: Area where data transferred from computer is stored (see “Using the Data Download Service” on page E-82). After transfer,
you can use the keyboard to edit parameters, but you can only overwrite existing parameters. You cannot save the data to
another number. Initially, nothing is stored in the user tone with wave memory area.
*3: Area where data transferred from computer is stored (see “Using the Data Download Service” on page E-82). Transfer only is
allowed, and no parameter editing is allowed. Initially, nothing is stored in the user drum set with wave memory area.
*4: User tones created by modifying parameters of one of the preset tones (000 to 049). User drawbar organ tone areas initially
contain two sets of the same data as drawbar organ tones types 000 through 049.
You can create an original tone using a user tone that includes a waveform (tone number 700 to 719). In this case, the storage area
is the same as the source tone area. For example, an original tone created using tone number 700 as a source tone is stored in user
area number 700.
Saving User Tones
705A-E-048A