Filter
Top Products
Mixer Function
E-42
z Octave Shift (Range: –2 to 0 to +2)
You can use octave shift to shift the range of the tone up or
down. When using the piccolo tone, there may be cases when
very high notes you want to play are not included within the
range of the keyboard. When this happens, you can use
octave shift to shift the keyboard range one octave up.
You can use these parameters to tune each of the parts
individually.
z Coarse Tune (Range: –24 to 00 to +24)
This parameter controls the coarse tuning of the selected
channel’s pitch in semitone units.
z Fine Tune (Range: –99 to 00 to +99)
This parameter controls the fine tuning of the selected
channel’s pitch in cent units.
The Mixer lets you control the effects applied to each
individual part, making it different from the Effect Mode,
whose settings are applied to all parts in general.
z Reverb Send (Range: 000 to 127)
This parameter controls how much reverb is applied to a part.
A setting of “000” turns reverb off, while a setting of 127
applies maximum reverb.
“Reverb Send” does not work with some drum sounds.
z Chorus Send (Range: 000 to 127)
This parameter controls how much chorus send is applied to
a part. A setting “000” turns chorus send off, while a setting
of 127 applies maximum chorus send.
“Chorus Send” does not work with drum sounds.
z DSP Line (Settings: on, oFF)
You can use this parameter to turn DSP line off for a particular
channel, or to turn it on.
z DSP Level (Range: 0 to 127)
Sets the post-DSP volume.
z DSP Pan (Range: –64 to 0 to 63)
Sets the post-DSP stereo pan.
–2 :Range shifted two octaves down.
–1 :Range shifted one octave down.
0 :No shift
+1 :Range shifted one octave up.
+2 :Range shifted two octaves up.
Tuning Parameters
Effect Parameters
DSP Part Parameters
705A-E-044A