Filter
Top Products
E-63
Song Memory Function
5. Make any changes in the value that you want.
The actual procedures you use to change a
parameter depend on the type of data it contains.
See “Editing Techniques and Display Contents”
on page E-63 for details.
Repeat steps 4 and 5 to edit other parameters.
6. Press the START/STOP button to end editing
when you are finished.
The only parameters that can be editted for Tracks 2
through 6 are notes and tone numbers.
In the case of real-time recording, you later can change
tone numbers you specified while recording to Tracks 1
through 6 is in progress.
You can only change tone numbers that were originally set
for Tracks 2 through 6 using step recording.
In the case of real-time recording, you later can change
rhythm numbers you specified while recording to Track 1 is
in progress.
You can only change rhythm numbers that were originally
set for Track 1 using step recording.
You cannot use the edit procedure to add more data to a
recording.
You cannot move portions of a recording to a different
location within the recording.
Note lengths cannot be changed.
The following describes the editing techniques you can use to
change the various parameters stored in memory.
J To change the key pressure (velocity) of a note
Use the number buttons or [
+
] and [–] to adjust the key
pressure.
J To change the pitch of a note
Input a new note on the keyboard to change the pitch of a
note. The pitch you specify here is reflected in the keyboard
and the notes shown in the staff on the display.
Whenever editing memory contents, never change a note
so it is identical to the note before or after it. Doing so may
alter the length of the changed note and the note before or
after it. Should this happen, you will have to re-record the
entire track.
J To change a chord
Use the chord fingering method selected by the MODE button
(FINGERED, CASIO CHORD, etc.) to input a chord.
J To change a tone number
Use the number buttons or [
+
] and [–] buttons to change a
tone number.
In the case of real-time recording, you later can change
tone numbers you specified while recording to Tracks 1
through 6 is in progress.
You can only change tone numbers that were originally set
for Tracks 2 through 6 using step recording.
J To change a rhythm number
Use the number buttons or [
+
] and [–] buttons to change a
rhythm number.
In the case of real-time recording, you later can change
rhythm numbers you specified while recording to Track 1 is
in progress.
You can only change rhythm numbers that were originally
set for Track 1 using step recording.
Editing Techniques and Display Contents
705A-E-065A