Filter
Top Products
Using Effects
(continued)
48
You can invert the brightness and color of the image to turn it into a negative.
1
Set the [MEMORY] knob to memory number 1.
* The factory preset settings are assigned to memory number 1. For details on
the [MEMORY] knob, refer to “Storing the Operating Panel Settings” (p. 28).
2
Press a bus A INPUT SELECT button to select an image.
3
Move the video fader to the bus A position to output the bus A image.
4
Press the bus A EFFECTS [2 (NEGATIVE)] button to turn on the Negative effect.
The [2 (NEGATIVE)] button will blink, and the Negative effect will be applied to
the bus A output image.
5
Operate the bus A [CONTROL] fader to modify the brightness inversion or color inversion.
* The blinking of the [2 (NEGATIVE)] button indicates that you can use the
[CONTROL] fader to modify the brightness inversion or color inversion.
6
Press the [2 (NEGATIVE)] button once again to turn off the Negative effect.
The [2 (NEGATIVE)] button will go out.
Inverting the Image to Form a Negative
Changing the Color of the Image
• For each bus, you can use up to four effects simultaneously. However, there are some combinations of effects that cannot
be used simultaneously. For details, refer to “Effects that Cannot Be Used Simultaneously” (p. 107).
• You can change the effect that is assigned to the [2 (NEGATIVE)] button. For details, refer to “Assigning Different Effects
to the EFFECTS Buttons” (p. 53).
V-8_e.book 48 ページ ２０１０年４月１６日 金曜日 午後５時１４分