Filter
Top Products
75
Using the V-8 with Other Equipment
(continued)
Input/output
settings
Introduction Connections Basic operation Switching images Effects BPM sync External devices Video fader Appendices
By switching the V-8’s operating mode to “PR Control mode,” you’ll be able to control the V-8 from an Edirol PR-80/50
(subsequently referred to as the PR series device) via MIDI.
In PR Control mode, you’ll be able to perform the following operations from the PR series device.
●
Switch between the image being input to the V-8 and the image of the PR series simply by operating the PR series device.
●
Use the Scheduler function of the PR series unit to operate the V-8 automatically.
Use version 1.2 or later for the PR series.
* For details on settings and operation for the PR series, refer to the PR series owner’s manual.
1
Press the [MENU] button to access the menu, and select “MIDI Setup.”
2
Use the [ ] [ ] buttons to select “PR Control,” and press the [ENTER] button.
3
Use the [ ] [ ] buttons to select “On.”
When this is “On,” you’ll be able to control the V-8 from the PR series unit.
4
Press the [MENU] button several times to close the menu.
Connection example
Switching to PR Control mode
Using the V-8 in Conjunction with the PR Series
(PR Control mode)
V-8 Rear panel
Composite or S-Video
Composite or S-Video
PC1 or PC2
MIDI IN
USB MIDI Interface
(
UM-1EX etc.)
PR-80/50
Computer
DV camera etc.
V-8_e.book 75 ページ ２０１０年４月１６日 金曜日 午後５時１４分