Filter
Top Products
66
“Copy From Program” has been added to the page menu
commands of pages such as Combination P0 (0–1 ☞PG
p.33).
0–1C: Copy From Program
This command copies the settings of the specified program
to a timbre of the currently selected combination. The effect
settings and arpeggiator settings of the specified program
can be copied as well, replacing the Combi’s effect and
arpeggiator settings.
1 Select “Copy From Program” to open the dialog box.
2 Use “Program” to select the copy-source program.
3 If you check “with Effects,” the insert effect, master
effect, and master EQ settings will also be copied. The
“Control Channel” of each effect will be set to the MIDI
channel of the copy-destination timbre.
About the BUS Select (8–1b/8–2a ☞PG p.46) setting
• Regardless of the “with Effects” setting, “BUS
Select” will be set to DKit if the copy-source
program’s “Use DKit Setting” is checked. In
conjunction with this, the “DrumKit IFX Patch”
setting will be reset to the default setting.
• If “with Effects” is checked, the “Bus Select” setting
of the copy-source program will be copied. If the
copy-destination timbre “BUS Select” was set to
IFX1–IFX5, it will automatically be set to L/R.
• If “with Effects” is unchecked, then the copy-source
“BUS Select” setting will be ignored. or if the “BUS
Select” of the copy-source program and copy-
destination timbre is set to IFX1–IFX5, it will
automatically be set to L/R.
4 If you check “with Arpeggiator,” the arpeggiator set-
tings of the copy-source program will be copied to the
arpeggiator you specify in step
6. In conjunction with
this, “Arpeggiator Run” will be set to the “checked”
state for the arpeggiator you specify in step
6, and the
copy-destination timbre’s “Arpeggiator Assign” will be
set to the arpeggiator you specify in step
6.
5 Use “To” to specify the copy-destination timbre.
The parameters specific to that timbre will be initialized.
The copy-source program will be specified for “Program
Select” (0–1c ☞PG p.51).
• The “MIDI Channel” (2–1b ☞PG p.38) setting will
not change if “with Arpeggiator” is checked. If “with
Arpeggiator” is unchecked, “MIDI Channel” will be
automatically set to Gch.
• The “Bank Select (When Status=EX2”) (2–1b ☞PG
p.38) setting will not change.
• The “Status” (2–1b ☞PG p.38) setting will
automatically be set to INT.
• If the copy-source is a program from the INT-F bank,
the “Voice Allocation Reserve” (☞EM p.47) of the
copy-destination track will be set to 6, and the “Voice
Allocation Reserve” setting of the other timbres will
be set to 0. Also, the “MOSS BUS Select Reference”
(☞EM p.47) setting will be automatically set to the
copy-destination timbre.
• The 1–4: Controller (☞PG p.12) settings of the copy-
source program will be copied.
6 Use “Arpeggiator” to specify the copy-destination arpeg-
giator.
7 Press the OK button to execute the copy. If you decide
not to execute, press the Cancel button.
Add the contents of “0–1C: Copy From Program” to the
explanation of “Parameter Guide” Combination mode 0–1:
Prog. Select Page Menu Command (
☞
PG p.35).
Copy From Program
0–1C