M-Audio Axiom Pro Electronic Keyboard User Manual


  Open as PDF
of 75
 
|
29
Axiom Pro User Guide
Edit Mode > Control
press 2
The Edit Mode > Control page contains parameters relating to the operation of a specific control on Axiom Pro (i.e., an individual
pad, encoder knob, button, etc.).
The Control page is automatically set to modify the last item that was manipulated before entering Edit mode. For example, if you
adjustedthemodulationwheelpriortoenteringtheEditMode>Controlpage,themodulationwheelwillbeselectedforediting.
Alternatively, different groups of controllers (pads, encoders, etc.) can be selected by turning encoder knob E2. Encoder knob E3
can then be used to select the specific control (i.e., the individual pad, encoder, etc.) that you would like to modify. Finally, the
Axiom Pro controls (encoder knobs, pads, etc.) that can be programmed in “profiles” can be accessed by using encoder knob E4.
Parameter: Name
Value Range: (varies)
This parameter lets you name the control that is currently selected for editing.
Editing Name Parameters:
To edit the name parameter found on any of the Edit Mode pages:
< Select the Name parameter and Press Soft Key 4 (Enter)
< Use the lower row of Encoder Knobs to select letter, numbers, and characters:
  •TurnEncoderknobE5toselectcapitalletters
 •TurnEncoderknobE6toselectlower-caseletters
 •TurnEncoderknobE7toselectnumbers
 •TurnEncoderknobE8toselectadditionalcharacters(suchasspaces,parentheses,exclamation
points, etc.)
< “Use Encoder knob E1 or Soft Keys 2 and 3 to move the editing prompt left and right
Once you have finished editing a Name parameter, press Soft Key 4 (Enter) to confirm your change. To cancel
any changes you have made, press Soft Key 1 (Exit).
 previous next