Filter
Top Products
E-50
Rv b Send
Effect Parameters
The Mixer lets you control the effects applied to each
individual part, making it different from the Effect Mode,
whose settings are applied to all parts in general.
■
Reverb Send (Range: 000 to 127)
This parameter controls how much reverb is applied to a part.
A setting of “000” turns reverb off, while a setting of 127
applies maximum reverb.
•“Reverb Send” does not work with some drum sounds.
■
Chorus Send (Range: 000 to 127)
This parameter controls how much chorus send is applied to
a part. A setting “000” turns chorus send off, while a setting
of 127 applies maximum chorus send.
•“Chorus Send” does not work with drum sounds.
■
DSP Line (Settings: on, oFF)
You can use this parameter to turn DSP line off for a particular
channel, or to turn it on.
DSP Part Parameters
■
DSP Level (Range: 0 to 127)
Sets the post-DSP volume.
■
DSP Pan (Range: –64 to 0 to 63)
Sets the post-DSP stereo pan.
DSP Le v e l
DSPPan
D.RvbSnd
D.ChoSnd
Mixer Function
735A-E-052A
■
DSP System Reverb Send (Range: 000 to 127)
This parameter adjusts how much reverb is applied to all
parts.
■
DSP System Chorus Send (Range: 000 to 127)
This parameter adjusts chorus.
NOTE
• Changing the tone, volume, pan pot, coarse tune, fine
tune, reverb send, or chorus send setting causes the
corresponding MIDI message to be output from the MIDI
terminal.
• Changing the tone settings changes the tone, octave
shift, reverb send, chorus send, and DSP line* parameter
settings.
* When DSP is off (See the note on page E-82.)
• Turning on the Mixer’s DSP Line parameter (page E-
49) causes the settings of the DSP Pan, DSP System
Reverb Send, and DSP System Chorus parameters to
be used in place of the Pan Pot, Reverb Send, and
Chorus Send parameters.
DSP L i ne
Ch o Se n d
WK3000_e_47-58.p65 03.4.8, 11:5150