Filter
Top Products
E-57
Synthesizer Mode
735A-E-059A
DSP Settings
Use the DSP editing screen to select the DSP type and to edit
parameters.
1
Select a tone, press the SYNTH button, and then
configure parameter settings.
2
After everything is the way you want, press the [̄]
CURSOR button once.
• This advances to the DSP parameter editing screen.
• Pressing the [̆] CURSOR button returns to the
Synthesizer Mode parameter screen.
This setting specifies DSP parameters. See “DSP Parameters”
on page E-33, “Effect List” on page A-17, and “DSP Algorithm
List” on page A-19 for more information.
NOTE
• If you store an original tone with the DSP line turned on
(see next page), simply recalling the tone automatically
changes the DSP line, DSP type, and DSP parameter
settings. This simplifies the recall of original tones that
include a DSP effect.
User Tone Creation Hints
The following hints provide helpful advice on making user
tone creation a bit quicker and easier.
Use a preset tone that is similar to the one you are trying to
create.
Whenever you already have a rough idea of the tone you are
trying to create, it is always a good idea to start with a preset
tone that is similar.
■
Experiment with various different settings.
There are no real rules about what a tone should sound like.
Let your imagination run free and experiment with different
combinations. You may be surprised at what you can achieve.
Storing a User Tone In Memory
The following procedure shows how to store a user tone in
memory. Once a tone is stored, you can call it up just as you
do with a preset tone.
To name a user tone and store it in
memory
1
Select a preset tone to use as the basis for the user
tone, press the SYNTH button to enter the
Synthesizer Mode, and make the parameter settings
you want.
2
After making parameter settings to create the user
tone, press [̄] CURSOR twice.
3
Use [+] and [–] to change the user area tone number
on the display until the one where you want to
store the tone is shown.
• You can select any tone number from 600 to 699.
4
After the tone name is the way you want, press the
[̈] CURSOR button to store the tone.
• Use the [+] and [–] buttons to scroll through letters at
the current cursor location.
• Use the [̇] and [̈] CURSOR buttons to move the
cursor left and right.
• See the page E-103 for information about inputting
text.
SYNTH
CURSOR
[+]
/
[–]
WK3000_e_47-58.p65 03.4.8, 11:5257