Filter
Top Products
E-54
Creating a User Tone
Use the following procedure to select a preset tone and change
its parameters to create a user tone.
1
First, select the preset tone you want to use as a
basis for your user tone.
2
Press the SYNTH button.
• This enters the Synth Mode, which is indicated by the
pointer next to SYNTH on the display screen.
3
Use [̇] and [̈] CURSOR to display the parameter
whose setting you want to change.
• Each press of [̇] or [̈] CURSOR changes to the next
parameter. See “Parameters and Their Settings” on
this page for information on setting range for each
parameter.
4
Use [+] and [–] to change the setting of the currently
selected parameter.
• You can also use the number buttons to input a value
to change a parameter setting. See “Parameters and
Their Settings” on this page for information on setting
range for each parameter.
5
After you are finished editing the sound, press the
SYNTH button to exit the Synthesizer Mode.
Synthesizer Mode
735A-E-056A
Atk Time
Currently selected parameter
Parameter setting value
y
V i bDe l a
NOTE
• See “Storing a User Tone In Memory” on page E-57 for
details on saving user tone data to memory so it is not
deleted.
Parameters and Their Settings
The following describes the function of each parameter and
provides its setting range.
■
Attack Time (Range: –64 to 00 to +63)
Time it takes before the tone sounds after a key is pressed
■
Release Time (Range: –64 to 00 to +63)
Time the tone continues to sound after a key is released
■
Cutoff Frequency
(Range: –64 to 00 to +63)
High-band cutoff for the harmonic components of the tone
■
Resonance (Range: –64 to 00 to +63)
Resonance of the tone
Atk Time
Re l . T ime
q
C- o f f Fr
.
Resonan
SYNTH
CURSOR
[+]
/
[–]
MODULATION button lamp
●WK-3000
WK3000_e_47-58.p65 03.4.8, 11:5254