Filter
Top Products
Europa User Guide
Europa User GuideEuropa User Guide
Europa User Guide
How do I……..?
How do I……..? How do I……..?
How do I……..?
Page 43
Boot to Roland mode?
Boot to Roland mode?Boot to Roland mode?
Boot to Roland mode?
When booting Roland mode, be forewarned that if Europa has run already, preset bank C & D will
contain junk presets. Europa uses this area to store persistent state, such as the current patch edits, MIDI
channel, and other persistent board settings (not patches or presets though!). Recalling preset bank C OR
D under Roland mode may cause the board to crash! The Roland code does not check for invalid memory
settings and usually causes the board to lock up.
To boot Roland mode:
• Power off the Jupiter 6
• Press and hold the TAPE
TAPETAPE
TAPE button
• Power on the Jupiter 6
The board will boot to the original Roland code. NOTE: Patches and presets made with Europa will not
be available to the Roland code! See the next question for details on how to get Europa patches/presets to
NVRAM so the Roland code can see it…
Copy patches/presets from Europa to NVRAM so that Roland code can see them?
Copy patches/presets from Europa to NVRAM so that Roland code can see them?Copy patches/presets from Europa to NVRAM so that Roland code can see them?
Copy patches/presets from Europa to NVRAM so that Roland code can see them?
We’re not exactly sure why this is desirable (maybe to make a tape for someone who doesn’t have a
Europa?) but it is included for the sake of completeness.
• Power off the Jupiter 6
• Press and hold the Glissando
GlissandoGlissando
Glissando button
• Power on the Jupiter 6
• Wait for boot code E
EE
E-
--
-7
77
7 to show. DO NOT PRESS ANY KEYS OR BUTTONS!
• Power off the Jupiter 6
• Press and hold the TAPE
TAPETAPE
TAPE button to boot to Roland mode
• Power on the Jupiter 6
Any patches/presets edited while in Roland mode will NOT automatically appear in the Europa flash.
Also, Europa formatted presets will lose setting information, such as non-Roland mode supported
assignment modes, sequences, rhythms, etc.. since the Roland code does not have these features.
Restore all patches and presets from MIDI?
Restore all patches and presets from MIDI?Restore all patches and presets from MIDI?
Restore all patches and presets from MIDI?
Provided that the steps in the section (Save
SaveSave
Save
all
allall
all
patches
patchespatches
patches
and
andand
and
presets
presetspresets
presets
to
toto
to
MIDI?
MIDI?MIDI?
MIDI?) below were
followed, the only step required to restore all patches/presets is to simply play the sequence back to the
Jupiter 6.
The Jupiter 6’s front panel lights will shimmer or flicker during restoration – this is normal! The Jupiter 6
hardware requires that Europa strobe the front panel lights, and strobing is not possible when Europa is
writing to flash.
If these steps have not been followed, ensure that there is at least a 70 millisecond gap between all system
exclusive messages, otherwise restoration of patches/presets will be intermittent if not incomplete.