Roland A-PRO Electronic Keyboard User Manual


 
15
Installing the Driver
Steps to be performed on the A-PRO keyboard itself are marked by a symbol. Don’t connect the A-PRO to your computer until you are told to do so.
1 With the A-PRO disconnected, start up Windows.
Disconnect all USB cables from your computer, with the exception of those for a
USB keyboard and USB mouse (if used).
2 Close all currently running software.
3 Insert the included A-PRO CD-ROM into your CD-ROM drive.
4 On the CD-ROM, open the [Driver] folder and then the [XP] folder,
and double-click the [Setup] icon.
If you get a message saying “The operating system you are using is not supported”
or saying that the application is invalid, check the version of your operating
system.
If the “Install Program As Other User” dialog box appears, click [Cancel] to
terminate the installation, log on to Windows using an administrator account, and
perform the installation once again.
5 The screen will indicate “A-PRO Driver will be installed on your
computer.” Click [Next].
If any other message appears, proceed as directed by the message.
6 To begin the installation, click [Next].
fig.xpdrv2-e.eps_27
If the “Software Installation” dialog box appears, click [Continue Anyway] to
continue the installation.
If you are unable to proceed, click [OK] in the dialog box to terminate the
installation. Then change the setting as described in “Driver signing option
settings (Windows XP)” (p. 80), and perform the installation once again.
7 Set the A-PRO’s [POWER] switch to OFF.
8 When the “Ready to install the driver” message
appears, use a USB cable to connect the A-PRO to your computer.
fig.xpdrv4-e.eps_27
If any other message appears, proceed as directed by the message.
9 Set the A-PRO’s [POWER] switch to USB.
The indication “Found New Hardware” will appear in the lower right corner of your
screen.
* It may take between ten seconds to several minutes for the “Found New Hardware
Wizard” to appear.
Windows XP Users
Operation of the A-PRO
Operation of the A-PRO
Operation of the A-PRO
Operation of the A-PRO
A-300_500_800C_e.book 15 ページ 2010年2月22日 月曜日 午後9時13分