Filter
Top Products
53
Assigning MIDI Messages (EDIT Mode)
Here’s how to assign an RPN or NRPN to a controller.
1 Press the [ACT] button and [ ] button simultaneously.
2 Slightly move the controller to which you want to assign a control
change message.
If the controller is a button, press it.
The number of the selected controller will blink in the display.
3 Verify that the display, then press the [ENTER] button.
fig.lcd-rpn.eps
4 Turn the [VALUE] knob until “RPN”
appears in the display.
* If you want to assign an NRPN message, get “NRPN” to appear in the display. The
rest of the procedure is the same as for RPN.
fig.lcd-midichannel.eps
5 Press the [ENTER] button.
The display will indicate the currently
specified MIDI transmit channel.
6 Use the [VALUE] knob to specify the desired MIDI transmit channel.
7 Press the [ENTER] button.
fig.lcd-rpnmsb.eps
8 Use the [VALUE] knob to select the
desired RPN MSB (CC#101) or NRPN
MSB (CC#99).
9 Press the [ENTER] button.
10 Use the [VALUE] knob to select the desired RPN LSB (CC#100) or
NRPN LSB (CC#98).
11 Press the [ENTER] button.
12 As appropriate for the controller type, specify the desired “Button
mode setting” (p. 55) or “Virtual center click setting” (p. 55).
RPN/NRPN Assignment
Data entry MSB (CC#6) range Data entry LSB (CC#38) range Port
0–127 (00–7FH) not transmitted PORT1
A-300_500_800C_e.book 53 ページ ２０１０年２月２２日 月曜日 午後９時１３分