Filter
Top Products
MIDI parameters
Backing Keyboard BK-5
r
105
Rx Event
The “Rx Event” section provides a number of filters
that allow you to specify whether the messages in
question should be received (On) or not (Off).
Edit Tone Parts
The following parameters are located on the display
page that can be selected using [MENU] button‰
“MIDI” ‰ “Edit Tone Parts”.
1.
Use the [CURSOR÷VALUE] dial to select the
part you want to edit (Upper1, Upper2,
Lower, Mel.Intell).
2.
Press the [ENTER/SELECT] button.
The display now shows the settings for the selected
part.
Tx, Tx Ch, Tx Shift, Tx Local, Tx Event
For the explanation of these parameters please refer
to page 104.
Rx, Rx Ch, Rx Shift, Rx Limit Low/High, Rx Event
For the explanation of these parameters please refer
to page 104.
Edit Song Parts
The following parameters are located on the display
page that can be selected using [MENU] button‰
“MIDI” ‰ “Edit Song Parts”.
1.
Use the [CURSOR÷VALUE] dial to select the
part you want to edit (Part 1~16).
2.
Press the [ENTER/SELECT] button.
The display now shows the settings for the selected
part.
Tx, Tx Ch, Tx Shift, Tx Local, Tx Event
For the explanation of these parameters please refer
to page 104.
Rx, Rx Ch, Rx Shift, Rx Limit Low/High, Rx Event
For the explanation of these parameters please refer
to page 104.
Filter Setting Explanation
Program
Change
Off, On Select “On” to receive pro-
gram change and bank
select (CC00, CC32) mes-
sages.
Pitch Bender Off, On Select “On” to receive Pitch
Bend messages.
Modulation Off, On Select “On” to receive Mod-
ulation messages (CC01).
Volume Off, On Select “On” to receive Vol-
ume messages (CC07).
Panpot Off, On Select “On” to receive Pan-
pot messages (CC10).
Expression Off, On Select “On” to receive
Expression messages
(CC11).
Reverb Off, On Select “On” to receive
Reverb messages (CC91).
Chorus Off, On Select “On” to receive Cho-
rus messages (CC93).
Hold Off, On Select “On” to receive Hold
messages (CC64).
Sostenuto Off, On Select “On” to receive Sos-
tenuto messages (CC66).
Soft Off, On Select “On” to receive Soft
messages (CC67).
Caf Off, On Select “On” to receive Caf-
Channel aftertouch.
RPN Off, On Select “On” to receive Reg-
istered parameter number
messages (CC100/101).
NRPN Off, On Select “On” to receive Non-
registered parameter num-
ber messages (CC98/99).
System
Exclusive
Off, On Select “On” to receive Sys-
tem Exclusive messages.
CC16 Off, On General purpose controller
that allows you to influence
the “C1” parameter (see
p. 60). Select “On” to receive
this message type.
Select All Off, On Select “On” to receive all
MIDI message listed above.
BK-5_US.book Page 105 Monday, November 14, 2011 12:43 PM