Filter
Top Products
10
Introduction
1
Security Slot
http://www.kensington.com/
2
MODE jack
Connect an optional footswitch (such as the BOSS FS-5U) here.
The function is the same as that when the [ ] and [ ] pedals are held down
simultaneously.
3
EXP PEDAL/CTL jack
Connect an optional expression pedal (such as the Roland EV-5, BOSS FV-500L/FV-
500H) or footswitch (such as the BOSS FS-5U/FS-6) here.
4
AMP CONTROL 1, 2 jack
When using the AMP CONTROL function, connect to the jack used for switching
guitar amp channels.
5
MIDI connectors (OUT, IN)
Connect an external MIDI device to these connectors to transmit and receive MIDI
messages.
6
RRC2 OUT connector
You can connect an external RRC2 IN device here to transmit and receive
performance data between the devices.
At the same time, the FC-300 can be powered by the external RRC2 IN device.
7
POWER switch
Turns the power on and off.
8
DC IN (AC Adaptor) jack
Connect the AC adaptor (PSA series; sold separately) here.
9
Cord Hook
Hook the AC adaptor cord here to prevent the adaptor plug from being
disconnected. Refer to
“Connecting an AC Adaptor”
(p. 12).
Rear Panel
1
2
3
4
6
5
8
7
9
Be sure to connect the RRC2
OUT connector to a device
with an RRC2 IN connector.
Use of the connection with
other devices may cause
generation of heat and damage
to the equipment.
When running on power
supplied by an RRC2 IN
device, the power is switched
on regardless of the position of
the POWER switch.
RRC2 is a Roland standard
developed to enable two-way
communications between
RRC2 IN devices and RRC2
OUT devices, while supplying
power to the RRC2 OUT
device from the RRC2 IN
device, all with a single cable.
You must use only the PSA
series AC adaptor. Use of any
other adaptor may cause
overheating or malfunctions.
FC-300_e1.book 10 ページ ２００７年４月２４日 火曜日 午前１０時１０分