Filter
Top Products
19
Standard Mode
You can freely change the settings for each pedal.
1
In the Standard Mode’s top screen, press PARAMETER [ ].
2
Press PARAMETER [ ] [ ] to display the pedal setting screens.
3
Press VALUE [ ] [ ] to change the value.
MIDI Messages
This selects the MIDI messages to be transmitted.
fig.05-009
• OFF
These do not output MIDI messages.
• CC#1–CC#31, CC#33–CC#95
These output Control Change messages.
When the pedal is used as an expression pedal, consecutive values are output within
the range set with the Range setting. When the pedal is used as a control pedal or
other type of switch, the maximum value is output when the switch is on, and the
minimum value is output when the switch is off.
• MIDI START / MIDI STOP / MIDI CONTINUE / MMC STOP / MMC PLAY /
MMC DEF PLAY / MMC FAST FWD / MMC REWIND / MMC REC STROBE /
MMC REC EXIT / MMC REC PAUSE / MMC PAUSE
This transmits MIDI Realtime messages and MMC messages.
When assigned to an expression pedal, messages are output once the pedal is
pressed downward past the halfway point; when assigned to a control pedal or other
switch, the messages are output when the switch is on.
• P.BEND / CH.PRS
These transmit various Pitch Bend messages and Channel Pressure messages.
When assigned to an expression pedal, consecutive values are output within the
range set with the Range parameter. When assigned to a control pedal, the
maximum value is output when the switch is on, and the minimum value is output
when the switch is off.
Change the Pedal Settings
MIDI Message
FC-300_e1.book 19 ページ ２００７年４月２４日 火曜日 午前１０時１０分