Filter
Top Products
43
Patch Mode
MMC REC EXIT / MMC REC PAUSE / MMC PAUSE
This transmits MIDI Realtime messages and MMC messages.
When assigned to an expression pedal, messages are output once the pedal is
pressed downward past the halfway point; when assigned to a control pedal
or other switch, the messages are output when the switch is on.
• P.BEND/CH.PRS
These transmit various Pitch Bend messages and Channel Pressure messages.
When assigned to an expression pedal, consecutive values are output within
the range set with the Range parameter. When assigned to a control pedal, the
maximum value is output when the switch is on, and the minimum value is
output when the switch is off.
Range
This sets the range for values that are transmitted.
fig.05-009
Mode
This sets the switch mode.
fig.05-009
AMP Ctl Op (Amp Control Operation)
This selects whether or not the AMP CONTROL jack is to be controlled.
fig.05-009
Control of AMP CONTROL using a pedal when the AMP Ctl Op parameter is set to
ON and the AMP Pol. parameter (p. 50) is set to NORMAL is as shown below.
fig.05-009
Value
Explanation
LATCH
The ON and OFF will alternate each time you press the pedal.
MOMENTARY The value will be ON while you press the pedal, and OFF when you
release the pedal.
Minimum Maximum
The Range parameter is
enabled only when CC#,
P.BEND, or CH.PRS is
selected.
The Mode parameter and AMP
Ctl Op parameter are enabled
with control pedals and other
such switches. These
parameters are disregarded
when the pedal is used as an
expression pedal.
AMP CONTROL
1 jack
AMP CONTROL
2 jack
When the pedal is OFF
When the pedal is ON
Open
Guitar Amp
(amps channel switching jack)
FC-300
(AMP CONTROL jack)
Guitar Amp
(amps channel switching jack)
FC-300
(AMP CONTROL jack)
Closed
You can change the polarity of
the AMP CONTROL jacks. For
more detailed information, see
“Setting the Polarity of the
AMP CONTROL Jacks” (p.
50).
FC-300_e1.book 43 ページ ２００７年４月２４日 火曜日 午前１０時１０分