Filter
Top Products
41
Patch Mode
You can set the status of the AMP CONTROL jacks when patches are selected.
1
In the Patch Mode’s top screen, press PARAMETER [ ].
2
Press PARAMETER [ ] [ ] to select “AMP Ctl.”
3
Press PARAMETER [ ] [ ] to select “1” or “2” of the AMP Ctl.
4
Press VALUE [ ] [ ] to change the value.
Control of AMP CONTROL when the AMP Pol. parameter (p. 50) is set to NORMAL
is as shown below.
5
After making the changes, follow the instructions in “Storing (Saving)
Patches” (p. 44) to save the setting to a patch.
Setting the Amp Control
Value
Explanation
---
The AMP CONTROL jack is disabled.
OFF The AMP CONTROL jack is switched off (closed).
ON The AMP CONTROL jack is switched on (open).
AMP CONTROL
1 jack
AMP CONTROL
2 jack
You can change the polarity of
the AMP CONTROL jacks. For
more detailed information, see
“Setting the Polarity of the
AMP CONTROL Jacks” (p.
50).
When the AMP Ctl is OFF
When the AMP Ctl is ON
Open
Guitar Amp
(amps channel switching jack)
FC-300
(AMP CONTROL jack)
Guitar Amp
(amps channel switching jack)
FC-300
(AMP CONTROL jack)
Closed
FC-300_e1.book 41 ページ ２００７年４月２４日 火曜日 午前１０時１０分