Filter
Top Products
14
Introduction
The FC-300 features the following four modes. The pedals function differently
depending on the mode that’s selected.
This manual describes each mode separately, while explaining the items available in
a particular mode.
This mode is for sending Program Change messages and Control Change messages.
You can use the pedals to send any Program Change messages.
This mode is for sending Control Change messages.
You can use this mode to send the Control Change messages assigned to the pedals,
and enhance the expressiveness of a performance.
You can also store up to five sets, or configurations, of settings for all of the pedals
(Pedal Setting function).
This mode is for sending System Exclusive messages.
You can use this mode to operate other equipment that accepts SysEx messages sent
from the FC-300.
This mode is for transmitting multiple MIDI messages (MIDI streams) already saved
to patches.
Patches are areas of memory in which MIDI streams are stored; you can save up to
100 patches.
An individual patch can hold MIDI messages containing up to a maximum of
approximately 500 bytes.
Using Patch Mode, you can transmit groups of MIDI messages through one patch,
which allows you to switch the settings of multiple devices all at once.
About the MODES
Standard Mode (p. 16)
Control Change Mode (p. 21)
System Exclusive Mode (p. 28)
Patch Mode (p. 29)
See “Switching Modes” (p.
15) for an explanation of how
to choose a mode.
FC-300_e1.book 14 ページ ２００７年４月２４日 火曜日 午前１０時１０分