Filter
Top Products
57
Appendices
[Cause]
The batteries are depleted (6 x AA size).
[Solution]
Replace the batteries as soon as possible. (p. 11)
[Cause 1]
The internal memory became full at the time the patch was saved.
[Solution 1]
Delete any unnecessary patches. (p. 45)
[Cause 2]
The area of memory for the FC-300’s internal operations became full
while the patch was being edited (COPY, INS, etc).
[Solution 2]
Delete MIDI messages within the patch. (p. 40)
[Cause]
Too many MIDI messages were received in a short time from an
external MIDI device than could be processed correctly.
[Solution]
Reduce the amount of MIDI message data transmitted by the external
MIDI device.
[Cause]
There is a problem with the MIDI cable connection.
[Solution]
Check to make sure the cable has not been pulled out or is not
defective.
[Cause]
Too many RRC2 control messages were received in a short time from
an external RRC2 IN device than could be processed correctly.
[Solution]
Reduce the amount of control message data transmitted by the
external RRC2 IN device.
[Cause]
There is a problem with the RRC2 cable connection.
[Solution]
Check to make sure the cable has not been pulled out or is not
defective.
Error Messages
Battery Low!
Memory Full!
MIDI Buffer Full!
MIDI Offline!
RRC2 Buffer Full!
RRC2 Offline!
FC-300_e1.book 57 ページ ２００７年４月２４日 火曜日 午前１０時１０分