Filter
Top Products
53
Other Features
You can change the values of the Bank Select messages output in Standard Mode to
match the connected device. Values from the [ ] [ ] pedals are added to the
base values set here and then output. For details, refer to
“Setting the Method Used
for Transmitting Program Change messages in Standard Mode (PC Mode)”
(p.
47).
1
Press PARAMETER [ ] [ ] to select “MIDI:Bank Select.”
2
Press PARAMETER [ ] [ ] to select either “MSB” or “LSB.”
3
Press VALUE [ ] [ ] to make the setting.
4
When you’ve finished making the settings, press [UTILITY] or [EXIT].
On the FC-300, you can use System Exclusive messages to provide another FC-300
with identical settings, and save settings on a MIDI sequencer or other device.
Making the Connections
• When saving to a MIDI sequencer
Connect the FC-300’s MIDI OUT to the MIDI sequencer’s MIDI IN connector
with a MIDI cable.
• When transmitting data to another FC-300
Connect the sending FC-300’s MIDI OUT to the receiving FC-300’s MIDI IN
connector with a MIDI cable.
1.
Set the Device ID for the transmitting and receiving FC-300s to the same
ID (p. 52).
2.
Switch to the Bulk Load screen on the receiving FC-300 (p. 54).
Transmitting
1
Press PARAMETER [ ] [ ] to select “Bulk Dump.”
Setting the Bank Select Value
Transmitting Data to an External MIDI Device (Bulk Dump)
For instructions on operating
the MIDI sequencer, see the
owner’s manual that came
with your MIDI sequencer.
FC-300_e1.book 53 ページ ２００７年４月２４日 火曜日 午前１０時１０分