Filter
Top Products
32
Patch Mode
When a patch is selected with the [ ] and [ ] pedals and number pedals, the
MIDI messages saved to the patch are transmitted.
1
Press the [ ] pedal, and the numbers decrease by five; press the [ ]
pedal, and the numbers increase by five.
The BANK/NUMBER display and Number pedal indicators flash.
2
The numbers are selected by pressing the number pedals (1/6–5/10).
The patch for the selected number is selected (the pedal’s indicator lights), and the
MIDI messages in the ON stream within the patch are transmitted.
Additionally, other settings included in the patch are enabled. A current patch’s OFF
streams are transmitted before the newly selected patch’s ON streams are
transmitted.
Transmitting Patch Data
With the factory settings,
Program Change messages are
not transmitted just by
pressing the [ ] and [ ]
pedals.
To transmit Program Change
messages just by pressing the
[ ] and [ ] pedals, read
“Using the [ ] [ ]
Pedals to Make the Settings”
(p. 48).
You can program the FC-300
so that pressing the [ ] and
[ ] pedals changes patch
numbers ten at a time. For
details, refer to “Setting the
[ ] [ ] Pedal Step Size”
(p. 49).
You can release the number
pedal to transmit OFF stream
at a time. For more detailed
information, see
“Setting the
Timing for Transmission of
OFF MIDI Streams” (p. 40).
Patch Number 100 is indicated
as P.00.
FC-300_e1.book 32 ページ ２００７年４月２４日 火曜日 午前１０時１０分