Filter
Top Products
37
Settings for Each Function ([EDIT])
The process of changing tone parameters to create the tones you like,
and changing the settings for various functions is known as
“editing.”
When [EDIT] is pressed and the indicator is lit, the RD-300SX
switches to “Edit mode.”
You can save edited settings to Setups.
Edited settings are discarded when the RD-300SX’s power is turned
off, so be sure that any settings you want to keep are saved to a Setup.
For details, refer to
“Storing Settings to Setups ([WRITE])”
(p. 35).
However, you cannot save System content to the Setups. If you want
to save changes made to the system, perform the Write procedure
separately (p. 37).
You can set the following parameters in Edit mode.
* Some tones are set so no effects are applied.
Functions that affect the RD-300SX’s overall operating environment
are called “System functions.”
1.
Press [EDIT].
The indicator lights, and the RD-300SX switches to Edit mode.
2.
Press [INC] or [DEC] to select “System,” then press
[ENTER].
fig.disp.SYS
3.
Referring to the following, press the TONE SELECT button
to which the parameter you want to change is assigned.
The parameter name appears in the display while the button is
held down. When the button is released, the value for the
parameter is shown in the display.
4.
Press [INC] or [DEC] to set the value.
5.
If you want to save the setting, press [WRITE]. Then, press
[ENTER].
You can return to Step 2 by pressing [EXIT].
Unless they have been saved, these settings are lost when the
power is turned off.
Parameters That Can Be Set
System: Settings related to the functioning of the entire instrument
(p. 37)
Master Tune
Temperament, Key
Stretch Tune
Damper Pedal Polarity
Control Pedal Polarity
Setup Control Channel
Setup Pedal Shift
USB Driver
Common: Settings for pedal functions and other such functions
(p. 40)
MFX Zone
Control Pedal Function
Tone: Tone settings (p. 41)
Cutoff
Resonance
Attack Time
Decay Time
Release Time
Reverb Send Level
Fine Tune
Bend Range
Upper, Lower Zone: Zone settings (p. 42)
Key Transpose
Pan
Damper Pedal Switch
Control Pedal Switch
Bender Switch
Modulation Switch
Part: Part On/Off (p. 43)
1–16
Utility: Settings for backing up, Factory Reset, etc. (p. 44)
Bulk Dump Temporary
Bulk Dump Setup
Factory Reset
TX Mode
Local Control
Making System Settings
(System)
How to Make Settings
TONE
SELECT
button
Indication
Parameter
PIANO Master Tune (p. 38)
E.PIANO Temperament, Key (p. 38)
ORGAN Stretch Tune (p. 38)
STRINGS/
PAD
Damper Pedal Polarity (p. 38)
GUITAR/
BASS
Control Pedal Polarity (p. 39)
BRASS/
WINDS
Setup Control Channel (p. 39)
VOICE/
SYNTH
Setup Pedal Shift (p. 39)
RHY/GM2
USB Driver (p. 39)
RD-300SX_e.book 37 ページ ２００５年４月２０日 水曜日 午後３時４０分