Filter
Top Products
39
Settings for Each Function ([EDIT])
This switches the polarity of the pedal connected to the PEDAL
(CONTROL) jack on the rear panel.
On some pedals, the electrical signal output by the pedal when it is
pressed or released is the opposite of other pedals. If your pedal has
an effect opposite of what you expect, set this parameter to REVERSE.
If you are using a Roland pedal (that has no polarity switch), set this
parameter to STANDARD.
You can switch the RD-300SX’s Setups with MIDI messages from an
external MIDI device.
Set the MIDI Receive channel for receiving the MIDI messages
(Program Changes) from the external MIDI device to be used for
switching Setups.
When not switching Setups from an external MIDI device, set this to
OFF.
When the Control Channel settings are transmitted along with
the part’s MIDI receive channel, switching of Setups takes
priority over the switching of tones. For more on program
changes for switching Setups, refer to
“Switching Setups”
(p.
49).
You can use the pedal which is connected to the PEDAL (CONTROL)
jack on the rear panel as a dedicated switch for selecting Setup in
order.
The function set with Control Pedal Function (p. 40) cannot be
used when this is switched to ON.
If you intend to connect to a computer using the USB connector, you
need to make the following setting before you make the connection.
After changing settings, turn the power off and then on again.
There is no need to use the Write procedure for the USB Driver
settings.
Switching the Pedal’s Polarity
(Control Pedal Polarity)
Indication
Value
STANDARD
REVERSE
Using Program Change Messages
to Switch Setups
(Setup Control Channel)
Value
1–16, OFF
Using the Pedal to Switch Setup
(Setup Pedal Shift)
Indication
Value Description
OFF
You can use the pedal function
set with Control Pedal Func-
tion (p. 40).
ON This becomes a dedicated
switch for switching Setups.
Making the Settings for the USB
Driver
Indication
Value Description
Original
Select this when using the supplied
driver with a USB connection.
Generic
Select this when using a gener-
ic USB driver included with the
OS with a USB connection.
RD-300SX_e.book 39 ページ ２００５年４月２０日 水曜日 午後３時４０分