Filter
Top Products
45
Settings for Each Function ([EDIT])
Restoring Saved Settings to the RD-
300SX
When returning settings saved to an external sequencer back to
the RD-300SX, an Exclusive message is transmitted from the
external sequencer, then the data is received by the RD-300SX.
Be aware that when you restore Setups data to the RD-300SX,
the data in the RD-300SX will be overwritten and lost.
1.
Connect the RD-300SX and the external sequencer, using
an optional MIDI or USB cable (sold separately).
2.
Make sure that [EDIT] indicator is extinguished.
If the [EDIT] indicator is lit, press [EDIT] to turn the indicator
light off and put the RD-300SX in normal performance mode.
3.
Transmit (play back) the data from the external sequencer.
After playback of the Bulk Dump Setup data, the RD-300SX
writes the data to the internal memory. Be sure never to turn off
the power while this data is being written.
For details on transmitting exclusive data, refer to the owner’s
manual for your sequencer.
The settings stored in the RD-300SX can be returned to their factory
settings.
Executing “Factory Reset” results in deletion of the Setups (p.
34) and the System (p. 37). If you want to keep any data you
have stored, use the “Bulk Dump Setup” operation to save the
data to an external sequencer (p. 44).
* You cannot save the System settings by Bulk Dump.
1.
Press [EDIT].
The indicator lights, and the RD-300SX switches to Edit mode.
2.
Press [INC] or [DEC] to select “Utility,” then press [ENTER].
fig.disp.Utl
3.
Press [ORGAN].
fig.disp.Fctl
4.
Press [ENTER].
A confirmation screen (Sure?) appears.
To cancel the Factory Reset, press [EXIT].
5.
Press [ENTER] again to start the Factory Reset operation.
When the Factory Reset is completed, you can return to Step 2.
Never turn off the power during Factory Reset.
Restoring the settings to the
factory condition (Factory Reset)
RD-300SX_e.book 45 ページ ２００５年４月２０日 水曜日 午後３時４０分