Filter
Top Products
49
Connecting External MIDI Devices
Try Playing the RD-300SX from an External MIDI Device.
Making Connections
fig.04-05
1.
Before starting the connection procedure, make sure that
the power to all devices has been turned off.
2.
After reading “Connecting the RD-300SX to External
Equipment” (p. 12), connect an audio device/system or
headphones.
3.
Connect the external MIDI device with the MIDI cable as
shown in the figure above.
4.
As described in “Turning the Power On and Off” (p. 13),
turn on the power of each device.
Transmitting Bank Select (Controller Number 0, 32) and Program
Change messages from the external MIDI device to the RD-300SX
allows you to switch Setups and Tones.
Switching Tones (p. 19, p. 60)
The MIDI messages transmitted by the external MIDI device will be
received by the RD-300SX to select Setups as shown in the following
table.
When switching Setups, the MIDI channel of the transmitting device
must be matched to the RD-300SX’s controller channel (p. 39).
When switching individual parts, match the MIDI channel of the
transmitting device to the RD-300SX's receive channel. However, if
the same channel is set for both the control channel and receive
channel, the control channel takes priority, resulting in Setups being
switched.
Playing the RD-300SX’s
Internal Sound Generator
from an External MIDI Device
MIDI IN
MIDI OUT
RD-300SX
MIDI Sequencer
Selecting RD-300SX Sounds
from an External MIDI Device
Switching Setups
Number Bank Select Program Change
Number
MSB LSB
1–32 85 0 1–32
RD-300SX_e.book 49 ページ ２００５年４月２０日 水曜日 午後３時４０分