Filter
Top Products
130
Chapter 8 Parameters Guide COSM AMP
GTR AMP CLEAN / GTR AMP CRUNCH /
GTR AMP DRIVE / GTR AMP METAL
Parameter/
Range
Explanation
SP TYPE (Speaker Type)
Select the speaker type.
OFF This turns off the speaker simulator.
ORIG This is the built-in speaker of the amp you
selected with PREAMP TYPE.
1x8” This is a compact open-back speaker cabinet
with one 8-inch speaker.
1x10” This is a compact open-back speaker cabinet
with one 10-inch speaker.
1X12” This is a compact open-back speaker cabinet
with one 12-inch speaker.
2X12” This is a general open-back speaker cabinet
with two 12-inch speakers.
4X10” This is an optimal speaker cabinet for a large
enclosed amp with four 10-inch speakers.
4X12” This is an optimal speaker cabinet for a large
enclosed amp with four 12-inch speakers.
8X12” This is a double stack of two cabinets, each
with four 12-inch speakers.
MIC TYPE
This setting selects the simulated mic type.
DYN57 This is the sound of the SHURE SM-57, a
general-purpose dynamic mic used for in-
struments and vocals.
DYN421 This is the sound of the SENNHEISER MD-
421, a dynamic mic with an extended low-
frequency response.
CND451 This is the sound of the AKG C451B, a small-
diaphragm condenser mic for use with in-
struments.
CND87 This is the sound of the NEUMANN U87, a
classic large-diaphragm condenser mic.
FLAT Simulates a mic with perfectly flat response.
Produces a sonic image close to that of lis-
tening to the sound directly from the speak-
ers (on site).
MIC DIS (Mic Distance)
Simulates the distance between the mic and speaker.
Off MIC This setting points the mic away from the
speaker.
On MIC Provides conditions whereby the mic is di-
rected more towards the speaker.
MIC POS (Mic Position)
This simulates the microphone position.
CENTER Simulates the condition that the micro-
phone is set in the middle of the speaker
cone.
1–10cm Simulates the condition that the micro-
phone is moved away from the center of the
speaker cone.
BOTTOM
0–100
Extracts the low-frequency components of
the sound input to this effect, and adjusts
the amount added to the effect sound.
DIRECT MIX
0–100
Adjusts the volume of the direct sound.
LEVEL
0–100
Adjusts the volume.
Parameter/
Range
Explanation
VB-99_e.book 130 ページ ２００８年８月１８日 月曜日 午後１時１０分