Filter
Top Products
70
Chapter 7 Other Functions
The sensitivity of the D Beam controller can vary depending on the
amount of light in the vicinity of the controller and the object (e.g.,
hand, bass neck) used to operate it. Perform this adjustment so you
can control the tone in the intended range.
1.
Press [SYSTEM].
2.
Press PAGE [ ] [ ] to go to Page 2.
3.
Press [F6] (CALIB).
4.
Press PAGE [ ] to go to Page 1.
5.
Set the beam’s responsive range as you
actually operate the D Beam controller.
• First, hold the object you will use to activate the controller (your
hand, bass neck, etc.) at the point farthest from the VB-99 in the
range you want the controller to respond, and press [F1]
(SetMIN).
• Next, hold the object at the closest point in the range you want
the controller to respond, and press [F4] (SetMAX).
6.
Press [EXIT] several times to return to the Play
screen.
• The D Beam controller’s response may also vary with the stage
lighting used. Confirm operation of the controller by testing it
onstage under the actual illumination.
• If the set range is too narrow or if the positioning is not suitable,
the message “OUT OF RANGE! SET AGAIN.” appears. To keep
this message from appearing, change the range or position and
recalibrate.
• The controller may not function properly with spot lights or
other such lighting shining directly on it.
• Be sure to adjust the CALIBRATION directly above the D Beam
controller.
• When the message “MISSING THE TARGET!” appears, it
indicates that the calibration is not being performed correctly.
• The CALIBRATION setting is a system parameter, so the Write
procedure is not required.
Changing the Tone in Real
Time with the D Beam and
Ribbon Controllers
Adjusting the D Beam
(CALIBRATION)
OK!
VB-99_e.book 70 ページ ２００８年８月１８日 月曜日 午後１時１０分