Roland VB-99 Music Mixer User Manual


 
56
Chapter 5 Using MIDI
The table below shows the correspondence between the factory
default Program change Map and the Program Change messages
received when RX PC MAP is set to FIX.
* When setting
“OMNI MODE”
(p. 149) to OFF, be sure to match
“MIDI CH (MIDI Channel)”
(p. 149) to the external MIDI device’s
transmit channel beforehand.
Setting the MIDI Output Control
Change Number
This sets the Control Change numbers output when the VB-99’s
pedals and external pedals or the FC-300’s pedals and external
pedals are operated.
1.
Follow Steps 1–3 in “Setting the MIDI-Related
Functions” (p. 52) to display the MIDI screen.
2.
Press PAGE [ ] [ ] to display Page 7.
The TX CC screen appears.
3.
Use [F2] (SEL ) or [F3] (SEL ), the F2 or F3
knobs to select the controller you want to set.
4.
Use [F5] or the F5 knob to assign the Control
Change number to be transmitted when the
controller is adjusted.
When the controller selected with F2 or F3 is operated, the
Control Change message selected with F5 is transmitted.
* Control Changes message cannot be output if OFF is selected.
Bulk Dump
With the VB-99, you can use Exclusive messages to set another VB-99
to the same settings or to save effect sound settings to MIDI
sequencers and other such devices.
This transmission of data is referred to as bulk dump.
Data that can be transmitted is described below.
How to Transmit the Data
When Saving Data to a MIDI Sequencer
Connect the devices as shown below, then place the MIDI sequencer
in standby mode, so it is ready to receive Exclusive messages.
For information on how to operate the sequencer you are
using, refer to the owner’s manual that came with it.
Bank Select
Program
Number
Patch
Number
0
1 001
: : :
0 128 128
1 1 101
: : :
2 128 328
3 1 301
: : :
3 100 400
Displayed
Data Transmitted
ALL
All transmittable data (SYSTEM, GK SETTING,
GLOBAL, PATCH 001–200, FAVORITE SET-
TING)
SYSTEM SYSTEM parameters.
GK SETTING Settings content for GK SETTING
GLOBAL GLOBAL function settings
PATCH Settings for patch numbers 001–200
FAVORITE
SETTING
Settings content in FAVORITE SETTINGS 01–
10 for all effects
MIDI IN
MIDI OUT
VB-99_e.book 56 ページ 2008年8月18日 月曜日 午後1時10分