Filter
Top Products
44
Chapter 3 Global Device Settings (SYSTEM)
Setting upper and lower limits for the patches that can be switched
allows you to select only the patches you need.
1.
Press [SYSTEM].
2.
Press PAGE [ ] to display Page 3.
3.
Press [F1] (MISC).
4.
Press [F3] (FROM).
5.
Set the lower limit of the patch selection with
the PATCH/VALUE dial and [F3] (FROM) or the
F3 knob.
6.
Press [F4] (TO).
7.
Set the upper limit of the patch selection with
the PATCH/VALUE dial and [F4] (TO) or the F4
knob.
* These settings are enabled in the following situations.
• When the PATCH/VALUE dial is turned
• When patches are switched with the control switches or
other controls
• When SYSTEM CONTROL ASSIGN (p. 42) is used to
assign PATCH SELECT INC or PATCH SELECT DEC to
the FC-300’s control switches or expression pedal
switches
These settings have no effect on other FC-300 operations
or operations using an external MIDI device.
The text and icons in the LCD screen may be difficult to make out
sometimes, such as immediately after the VB-99 is turned on or after
extended use. The conditions at the place where you are using the
VB-99 can also affect visibility. Should you run into this problem, try
adjusting the contrast.
1.
Press [SYSTEM].
2.
Press PAGE [ ] to display Page 1.
3.
Press [F1] (LCD).
4.
Turn the F1 knob to adjust the contrast.
Limiting the Patches That
Can Be Switched (PATCH
EXTENT)
Adjusting the Screen’s
Contrast
VB-99_e.book 44 ページ ２００８年８月１８日 月曜日 午後１時１０分